Removal (Bronco II & Ranger)
- Rotate lock cylinder key to "LOCK" position. Disconnect battery ground. On tilt columns, remove upper extension shroud by squeezing at the 6 and 10 o'clock positions and popping free of the retaining plate at the 3 o'clock position.
- Remove 2 shroud halves by removing the 2 attaching screws. On all models, disconnect electrical connector from ignition switch. Drill out the 2 break-head bolts holding the ignition switch to lock cylinder with a 1/8" drill bit.
- Using an easy-out, remove bolts. Disengage the ignition switch from the actuator pin and remove switch.