Brake Booster: Removal
- Disconnect battery. Remove air cleaner. Remove hydraulic lines from outlet ports of master cylinder. On models with 2.3L engine, disconnect accelerator cable from carburetor and accelerator shaft bracket. Remove accelerator shaft bracket bolts at manifold and rotate toward engine. If necessary, remove horn.
- Disconnect wires from stop light switch, remove retaining clip from brake pedal pin and remove switch. Speed control equipped models remove and set aside control amplifier.
- Being careful not to bend or kink hydraulic lines, remove master cylinder from power unit without removing hydraulic lines and position out of way.
- Disconnect power push rod from brake pedal. Remove power unit from dash panel.