Drum Brake Shoe
NOTE:
This adjustment is made only after brake lining replacement or if brake applications are insufficient to actuate automatic adjuster.
- On all models except Escort, EXP, LN7 & Lynx with 7" brakes, use a measuring tool to determine drum diameter and proper shoe diameter. Hold automatic adjusting lever out of engagement while rotating adjusting screw and adjust brakes shoes to fit gauge. Rotate gauge around shoe to be sure of proper fit.
- On Escort, EXP, LN7 and Lynx with 7" brakes, pivot adjuster quadrant until it meshes with knurled pin and is in the 3rd or 4th notch of outboard end of quadrant. On all models, install drum and wheel. On Escort, EXP, LN7 and Lynx, adjust wheel bearings. See WHEEL BEARING ADJUSTMENT in appropriate article in the SUSPENSION section.
- On all models, complete adjustment by applying brakes several times while backing vehicle, with forward movement after each application. Use a minimum 50 lbs. (22 Kg) pressure on non-power breaks and 25 lbs. (11 Kg) on power brakes.
NOTE:
Do not allow lubricant to contact linings.