"F" Models
- Disconnect battery ground cable. Pull knobs from radio shafts (if equipped), fuel gauge switch knob, heater control knobs and wiper/washer knob. Use a hook tool to release each knob lock tab. Remove knob and shaft from light switch.
- Remove one nut and washer from each radio control shaft and remove radio bezel. Remove cluster trim cover attaching screws which are located along top of bezel (four screws), between headlight and wiper/washer switches (one screw), and below radio (two screws).
- Disconnect air conditioning duct (if equipped) and illumination light from bezel (light is located between headlight and wiper/washer switches).
- Remove four screws attaching cluster, disconnect speedometer cable, and wire connector from printed circuit. Remove cluster assembly from vehicle.
- To install, reverse removal procedure.