Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. Turn the ignition off, wait ten seconds then turn the ignition on.
3. With the scan tool, read DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
PERFORM THE PROXI CONFIGURATION ALIGNMENT ROUTINE IN THE RRM
1. With the scan tool, perform the PROXI Configuration Alignment Routine in the RRM, Miscellaneous Functions.
2. Follow the on-screen instructions.
3. Cycle the ignition.
4. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension. If all connections are OK, replace the Radio (RRM) in accordance with the Service Information. Refer to RADIO, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .