LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2021 >> 500X Pop >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster (Service Information) >> Removal And Installation >> Removal

Removal And Installation: Removal

GC0174109Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Using a small flat bladed tool, release the retaining tabs (1b) and remove the screw cover (1a).
  3. Remove the screw (2) for the instrument panel hood.
    GC0174207Courtesy of CHRYSLER GROUP, LLC
  4. Using trim stick or equivalent, release the retaining clips (1b) and remove the instrument cluster hood (1a).
  5. Remove the instrument panel center hood. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL AND INSTALLATION .
    GC0174426Courtesy of CHRYSLER GROUP, LLC
  6. Using trim stick or equivalent, remove the driver side instrument panel trim panel (1b).
    GC0174409Courtesy of CHRYSLER GROUP, LLC
  7. Remove the four screws (1a) from the steering column shroud gap hider (1c).
  8. Position the steering column shroud gap hider aside.
    GC0174599Courtesy of CHRYSLER GROUP, LLC
  9. Remove the three screws (1a) for the Instrument Panel Cluster (IPC) (1b).
    GC0174407Courtesy of CHRYSLER GROUP, LLC
  10. Pull the IPC (1b) from the instrument panel and disconnect the instrument panel wire harness (1a).
  11. Remove the IPC (1b) from the vehicle.
scientia non olet · About LEMON Manuals