Unit, Electric Vehicle Control (EVCU): Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

Connect the two electronic vehicle control unit (EVCU) electrical connectors (1), and install the EVCU (2).

Courtesy of CHRYSLER GROUP, LLC
Install and tighten the EVCU bracket bolts to 24 Nm (18 ft. lbs.).
Install the electric motor trim cover. Refer to MOUNT, MOTOR, INSTALLATION .
Power-up the 12-volt system. Refer to 12 VOLT POWER UP .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.