Heater, Air Electric (AEH): Installation
WARNING: This page is about a different variant/trim than selected.
WARNING:
When performing any repairs that involve contact with high voltage components or systems, the technician performing repairs on the vehicle must verify that the system remains powered down during high voltage repairs.
- This must be done by removing the service disconnect.
- The high voltage power down procedure must also be performed to ensure that the vehicle is properly powered down.
- The technician must know the whereabouts of the service disconnect throughout the repair.
- The technician must ensure that no one reconnects the service disconnect while service is being performed.
- The technician must recheck that the service disconnect has not been reinstalled in cases where the vehicle was unattended.
NOTE:
If installing a new air electric heater (AEH), new foam seals which are available as a separate service part kit must be installed on the new AEH. If the seals are not installed, or are damaged, airflow from the blower motor will bypass the AEH resulting in poor heating performance and NVH concerns.
- If installing a new air electric heater (AEH), install the new wide seal (1) around the side and bottom surfaces of the AEH element as shown.
- If installing a new AEH, install the new thin foam seal (1) along the surface where the AEH element meets the AEH module.
- Install the AEH (2) into the HVAC housing, and install the three AEH screws (1).
- Attach the AEH high-voltage electrical connector (2) to the connector bracket (1), and connect the AEH high-voltage electrical connector.
- Attach the connector bracket onto the HVAC housing until the release tab (1) engages.
- Install the AEH high-voltage wiring cover (2), and the three high-voltage wiring cover screws (1).
- Install the instrument panel. Refer to PANEL, INSTRUMENT, INSTALLATION .
- Power up the 12-volt battery system. Refer to 12 VOLT POWER UP .