LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Body - Interior & Exterior - 500 - Electric) >> Seats >> Cover, Seat Cushion, Front >> Assembly

Cover, Seat Cushion, Front: Assembly

WARNING: This page is about a different variant/trim than selected.
NOTE:

Passenger seat shown. Driver seat similar.

GC0153149Courtesy of CHRYSLER GROUP, LLC
  1. If necessary, install a new Occupant Detection Sensor (ODS) onto the passenger side seat bottom cushion. Refer to SENSOR, OCCUPANT DETECTION, INSTALLATION .
  2. If necessary, install a new heated seat pad onto the seat bottom cushion. Refer to PAD, HEATER, INSTALLATION .
  3. Position the seat bottom cover (1) onto the seat bottom cushion (3) and attach new hog rings (2).
    GC0153148Courtesy of CHRYSLER GROUP, LLC
  4. Engage the rear of the seat bottom cover (1) to the seat bottom cushion (2).
  5. Install the seat bottom cushion and cover. Refer to INSTALLATION  .
scientia non olet · About LEMON Manuals