Section 49 (Horn System (Service Information) 500 - Electric): Horn: Installation
WARNING: This page is about a different variant/trim than selected.
- Position the horn (3) and mounting bracket as a unit to the left outboard end of the Front End Module (FEM) carrier. Be certain to engage the anti-rotation tab of the mounting bracket into the locating hole in the FEM carrier.
- Install and tighten the screw (1) that secures the horn mounting bracket to the FEM carrier. Tighten the screw securely.
- Connect the wire harness electrical connector (2) to the horn.
- Install the splash shield to the left front wheel house. Refer to INSTALLATION .
- Perform the 12-Volt Power Up procedure. Refer to 12 VOLT POWER UP .