LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Base Brakes (Service Information) - 500 - Electric) >> Parking Brake >> Cable, Parking Brake >> Removal

Cable, Parking Brake: Removal

WARNING: This page is about a different variant/trim than selected.
GC0152743Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before proceeding. Refer to CAUTION , and Refer to WARNING .

NOTE:

The procedure below applies to either of the two parking brake cables.

  1. Disconnect and isolate the battery negative cable from its post on the battery.
  2. Block the tire and wheel assemblies so the vehicle does not move once the vehicle parking brake lever is released.
  3. Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL .
  4. Release and lower the parking brake lever (5).
  5. Loosen the adjusting nut (4) on the equalizer output cable and disconnect the brake actuation cables from the equalizer.
  6. Remove the parking brake cables from the parking brake cable equalizer (3).
    GC0152498Courtesy of CHRYSLER GROUP, LLC
  7. Raise and support the vehicle. Refer to HOISTING .
  8. Remove parking brake cable from each mounting bracket.
  9. Disconnect brake cable end (2) from caliper bracket and slide brake cable through bracket.
  10. Remove parking brake cable from vehicle.
scientia non olet · About LEMON Manuals