LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Base Brakes (Service Information) - 500 - Electric) >> Hydraulic/Mechanical >> Rotor, Brake >> Removal >> Rear Brake Rotor

Rear Brake Rotor

WARNING: This page is about a different variant/trim than selected.
NOTE:

Before proceeding. Refer to CAUTION , and Refer to WARNING .

  1. Raise and support the vehicle. Refer to HOISTING .
  2. Remove the tire and wheel assembly. Refer to REMOVAL .
    GC0176780Courtesy of CHRYSLER GROUP, LLC
  3. While holding the hex fitting on the caliper slides, remove caliper guide pin bolts (3).
  4. Remove caliper from mounting bracket and support with a bungee cord or wire. Do not let it hang from the brake hose.
  5. Remove caliper bracket mounting bolts (4) and remove caliper mounting bracket.
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  6. Remove retaining studs (1) and slide brake rotor off the hub and bearing.
scientia non olet · About LEMON Manuals