LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 35 (Rear Suspension - 500 - Electric) >> Spindle, Rear >> Removal

Spindle, Rear: Removal

WARNING: This page is about a different variant/trim than selected.
GC0152555Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before proceeding. Refer to WARNING .

  1. Raise and support the vehicle. Refer to HOISTING .
  2. Remove the wheel mounting bolts (1), then the rear tire and wheel assembly.
    GC0152557Courtesy of CHRYSLER GROUP, LLC
  3. Remove the hub and bearing dust cap (2).
  4. Remove the rotor mounting pins (1).
    GC0152831Courtesy of CHRYSLER GROUP, LLC
  5. Remove the caliper adapter bracket mounting bolts (7), then remove the disc brake caliper (6) and adapter as an assembly.
  6. Hang the caliper (6) out of the way using a wire hanger or bungee cord. Do not allow the caliper to hang by the flex hose; damage to the hose may occur. 
  7. Remove the brake rotor (3).
  8. Remove the hub nut (1) and washer (2), then slide the hub and bearing (4) from the spindle (5).
    GC0153402Courtesy of CHRYSLER GROUP, LLC
  9. On vehicles equipped with antilock brakes, remove the screw (2) securing the antilock brake wheel speed sensor to the hub. Remove the sensor head from the hub.
  10. Remove the four bolts (1) securing the spindle to the axle and remove the spindle from the axle.
scientia non olet · About LEMON Manuals