LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Heating & Air Conditioning (Service Information) 500 - Electric) >> Distribution >> Housing, HVAC >> Disassembly >> Housing-Air Inlet

Housing-Air Inlet

WARNING: This page is about a different variant/trim than selected.
NOTE:

Manual Temperature Control (MTC) shown. Automatic Temperature Control (ATC) similar.

GC0152574Courtesy of CHRYSLER GROUP, LLC
  1. Remove the HVAC housing assembly and place it on a workbench. Refer to HOUSING, HVAC, REMOVAL .
  2. Remove the air inlet housing from the HVAC housing. Refer to HOUSING, HVAC, REMOVAL .
  3. Remove the two screws (1 and 3) that secure the recirculation door actuator (2) to the air inlet housing (4) and remove the actuator.
    GC0152575Courtesy of CHRYSLER GROUP, LLC
  4. Remove the recirculation door coupler (1), located at the bottom of the air inlet housing (2). First, using a small flat bladed screwdriver, reach through the recirculation door grill and disengage the retaining tab, located on the bottom of the recirculation air door. Then pull the coupler straight out.
    GC0152577Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    If the foam seal on the air inlet housing is deformed or damaged, the seal must be replaced.

  5. Carefully cut the foam seal (1) along the parting lines (1 and 4) of the two halves of the air inlet housing (3).
    GC0152576Courtesy of CHRYSLER GROUP, LLC
  6. Remove the five screws (2, 4, 5 and 7) that secure the two halves of the air inlet housing together (1 and 5) and separate the housing.
    GC0152578Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    If a rubber seal on the recirculation air-door is deformed or damaged, the air-door must be replaced.

  7. Remove the recirculation air door (1) from the upper half of the air inlet housing (2).
scientia non olet · About LEMON Manuals