Duct, Floor Distribution: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
Right side floor duct shown. Left side similar.
NOTE:
If the foam seal on a floor duct is deformed or damaged, the seal must be replaced.
- Position each floor duct (2) to the HVAC housing (3), as necessary.
- Install the two screws (1) that secure each duct to the housing. Tighten the screws to 0.8 N.m (7 in. lbs.).
- Install the shifter housing trim panels. Refer to COVER, INSTRUMENT PANEL, INSTALLATION .