Transducer, A/C Pressure: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to 12-VOLT POWER DOWN .
NOTE:
It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
- Disconnect and isolate the 12-volt negative battery cable.
- Power down the high-voltage system. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE
.
- Disconnect the wire harness connector (1) from the A/C pressure transducer (2), located on the A/C liquid line (3).
- Remove the A/C pressure transducer from the A/C liquid line.
- Remove and discard the O-ring seal (1), located on the A/C liquid line fitting (2).