Sensor, Humidity: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to 12-VOLT POWER DOWN .
- Power down the high-voltage system. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE .
- Disconnect and isolate the 12-volt negative battery cable.CAUTION:
Use care when removing the humidity sensor. The humidity sensor bracket cannot be serviced separately from the windshield. If the sensor bracket becomes damaged, the windshield will need to be replaced.
- Carefully disengage the four retaining tabs (2 and 4) that secure the cover (3) to the humidity sensor bracket (1) by pressing in on the right side of the cover, while rocking the left side of the cover off the bracket.
- Using a small screwdriver or similar tool, carefully disengage the metal retaining clip (3) from the sensor bracket (2) and remove the humidity sensor (4) and the clip as an assembly.
- Disconnect the wire harness connector (1) from the humidity sensor.
- If the humidity sensor bracket is damaged and cannot be reused, replace the windshield. Refer to WINDSHIELD, REMOVAL .