Unit, Headlamp: Installation: Lamp

WARNING: This page is about a different variant/trim than selected.

NOTE:

The headlamp unit combines the low beam and high beam in a single headlamp unit.

Courtesy of CHRYSLER GROUP, LLC

Position the headlamp unit (2) close enough to the front of the vehicle to reconnect the wire harness connector to the receptacle on the back of the lamp housing.
Position the headlamp unit (2) onto the front fender and Front End Module (FEM) support structure.
Install and tighten the three screws (1) that secure the lamp to the vehicle. Tighten the screws to 10 N.m (89 in. lbs.).
Reinstall the fascia onto the front of the vehicle. Refer to FASCIA, FRONT, INSTALLATION .
Connect the 12 volt negative battery cable.
Power up the high voltage system. Refer to HIGH-VOLTAGE POWER UP .
Confirm proper headlamp alignment. Refer to STANDARD PROCEDURE - LAMP ALIGNMENT .