Lamp, Side Repeater: Installation: Bulb
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
- Align the base of the bulb (3) with the repeater lamp bulb socket (1).
- Push the bulb straight into the socket until the base is firmly seated.
- Be certain that a rubber O-ring seal (2) is properly installed and in good condition around the base of the bulb socket.
- Align the socket and bulb with the keyed opening on the back of the repeater lamp lens/housing.
- Insert the socket and bulb into the housing until the socket is firmly seated.
- Rotate the socket clockwise about 30 degrees to lock it into place.
- Reinstall the repeater lamp into the fender mounting hole. Refer to LAMP, SIDE REPEATER, INSTALLATION .
- Connect the 12 volt negative battery cable.
- Power up the high voltage system. Refer to HIGH-VOLTAGE POWER UP .