Lamp, Side Marker: Removal: Lamp
WARNING: This page is about a different variant/trim than selected.
NOTE:
A side marker lamp is integral to the front fascia forward of each front wheel opening and to the rear fascia behind each rear wheel opening.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to 12-VOLT POWER DOWN .
- On vehicles equipped with the high voltage system, power down the 12 volt system, Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12 volt battery cable.
- Remove enough of the fasteners that secure the front of the front wheel house splash shield to the front fascia, or the rear of the rear wheel house splash shield to the rear fascia to gain access to the back of the side marker lamp housing. Refer to REMOVAL .
- Disconnect the wire harness connector (1) from the side marker lamp bulb socket.
- Remove the two stamped nuts (2) that secure the lamp housing to the fascia.
- Remove the side marker lamp from the fascia.