Lamp, Fog: Removal: Lamp
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to 12-VOLT POWER DOWN .
- On vehicles equipped with the high voltage system, power down the 12 volt system, Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12 volt battery cable.
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the bezel (1) away from the front fascia (3) and the fog lamp (2) far enough to disengage the snap clips that secure it.
- Remove the three screws (2) that secure the fog lamp (1) to the front fascia.
- Pull the fog lamp away from the front fascia far enough to access and disconnect the wire harness connector from the bulb connector receptacle on the back of the lamp housing.
- Remove the fog lamp from the fascia.