Lamp, Fog: Removal: Bulb
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury. Refer to 12-VOLT POWER DOWN .
- On vehicles equipped with the high voltage system, power down the 12 volt system, Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12 volt battery cable.
- Remove the front fog lamp from the front fascia. Refer to LAMP, FOG, REMOVAL .
- Firmly grasp the fog lamp bulb (2) on the back of the front fog lamp housing (1) and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the bulb straight out from the keyed opening in the housing.