Front Fog Lamps
WARNING: This page is about a different variant/trim than selected.
| CONDITION | POSSIBLE CAUSES | CORRECTION |
|---|---|---|
| FRONT FOG LAMP DOES NOT ILLUMINATE | 1. Ineffective or missing bulb. | 1. Test and replace front fog lamp bulb if required. |
| 2. Ineffective ground circuit. | 2. Test and repair open front fog lamp ground circuit if required. | |
| 3. Ineffective feed circuit. | 3. Test and repair open front fog lamp feed circuit if required. | |
| 4. Ineffective front fog lamp switch. | 4. Test and replace front fog lamp switch (lower instrument panel switch pod) if required. | |
| 5. Ineffective BCM inputs or outputs. | 5. Use a diagnostic scan tool to test the BCM inputs and outputs. Refer to the appropriate diagnostic information. | |
| FRONT FOG LAMP DOES NOT EXTINGUISH | 1. Ineffective feed circuit. | 1. Test and repair shorted front fog lamp feed circuit if required. |
| 2. Ineffective front fog lamp switch. | 2. Test and replace front fog lamp switch (lower instrument panel switch pod) if required. | |
| 3. Ineffective BCM inputs or outputs. | 3. Use a diagnostic scan tool to test the BCM inputs and outputs. Refer to the appropriate diagnostic information. |