LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Control Modules (Service Information) 500 - Electric) >> Standard Procedure >> Module Programming

Module Programming

WARNING: This page is about a different variant/trim than selected.
  1. Connect the diagnostic scan tool to the vehicle.
  2. Check the vehicle for any Diagnostic Trouble Codes (DTC)s.
  3. Clear all stored DTCs.
  4. Turn the ignition OFF then back to ON and confirm that the DTCs are cleared.
  5. From the Vehicle View, Click on the BCM icon >> Misc. Functions >> and then perform the Proxi Configuration.

If required, continue to programming the next module.

scientia non olet · About LEMON Manuals