Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION. Refer to INTERMITTENT CONDITION .
VERIFY IF THIS DTC SET IN OTHER MODULES
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Are any other modules on the CAN BUS reporting this DTC?
  
  Yes
  - Replace and program the Body Control Module in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace and program the module that set this DTC in accordance to the Service Information. Perform its respective verification test.