LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) 500 - Except Electric >> Linkage, Wiper Arm >> Removal

Linkage, Wiper Arm: Removal

GC0152982Courtesy of CHRYSLER GROUP, LLC
NOTE:

The front wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Refer to MOTOR, WIPER, REMOVAL  .

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove both front wiper arms from the wiper pivots. Refer to ARM, WIPER, REMOVAL  .
  3. Remove the cowl plenum cover/grille panel from over the front wiper linkage module. Refer to COVER, COWL PANEL, REMOVAL .
  4. Remove the two screws (3) that secure the module bracket to the cowl plenum.
  5. Disengage the knob-like rubber insulator from the hole in the rearward wall of the cowl plenum.
  6. Disconnect the wire harness connector (2) from the connector receptacle for the front wiper motor.
  7. Disengage the wire harness retainer (1) from the linkage module bracket.
  8. Remove the front wiper linkage module from the cowl plenum as a unit.
scientia non olet · About LEMON Manuals