Diagnostic Test

CHECK THE ANTENNA CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Entertainment Telematic (ETM/LTM) Antenna connector.
3. Inspect the ETM/LTM Antenna connection.
  Was the Antenna connection clean and secure?
  
  Yes
  - Go To 2
  No
  - Repair the Antenna connection as needed.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE ANTENNA AND CABLE
1. Connect the Radio Diagnostic Tool (special tool #9977-6-FM, Antenna) to the Antenna connection on the back of the ETM/LTM.
2. Make sure one of the front doors is still open.
3. With the scan tool, erase DTCs.
4. Turn the ignition on.
5. Turn the ETM/LTM on.
6. With the scan tool, read ETM/LTM DTCs.
  Is the DTC active?
  
  Yes
  - Repair or replace the ETM/LTM in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
TEST THE ANTENNA CABLE
1. Turn the ignition off.
2. Disconnect the Antenna cable at the base.
3. Connect the appropriate Radio Diagnostic Tool (special tool #9977-6-1, Adapter) or (special tool #9977-6-3, Adapter) to the Antenna cable at the back of the ETM/LTM.
4. Connect the appropriate Radio Diagnostic Tool (special tool #9977-6-4, Jumper) or (special tool #9977-6-2, Jumper) to the Antenna cable at the Antenna base.
5. Measure the Resistance across the tool terminals.
  Is the resistance above 52.5 Ohms?
  
  Yes
  - Use the Radio Diagnostic Tool (special tool #9977-6, Kit, Radio Antenna Diagnostic) to locate the open circuit, repair or replace the Antenna cable as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Antenna base in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .