Diagnostic Test

CHECK THE ANTENNA CONNECTION
1. Turn the ignition off.
2. Disconnect the Antenna connector at the back of the Radio.
3. Inspect the Antenna connections.
  Are the Antenna connections clean and secure?
  
  Yes
  - Go to 2
  No
  - Repair the Antenna connection as needed.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE ANTENNA AND CABLE
1. Connect the 9977-6-GPS test antenna (special tool #9977-6-GPS, Adapter, GPS Antenna Diagnostic) to the antenna connection on the back of the Radio.
2. Make sure one of the front doors is still open.
3. Using the scan tool, erase the DTCs.
4. Turn the ignition on.
5. Turn the Radio on.
6. Using the scan tool, read the active Radio DTCs.
  NOTE:
  While using the 9977-6-GPS test antenna the Satellite radio reception will not be available and Satellite radio faults may occur. The 9977-6-GPS test tool will only enable GPS reception to work. For Satellite Radio reception concerns use test antenna 9977-6-SAT.
  
  Is the DTC active?
  
  Yes
  - Replace the Radio in accordance with the Service Information. (Refer to RADIO .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go to 3
TEST THE ANTENNA CABLE
1. Disconnect the Antenna cable at the base.
2. Connect the appropriate (special tool #9977-6-1, Adapter) or (special tool #9977-6-3, Adapter) to the Antenna cable at the back of the Radio.
3. Connect the appropriate (special tool #9977-6-4, Jumper) or (special tool #9977-6-2, Jumper) to the Antenna cable at the Antenna base.
4. Measure the Resistance across the tool terminals.
  Is the resistance below 47.5 Ohms?
  
  Yes
  - Use the (special tool #9977-6, Kit, Radio Antenna Diagnostic) to locate the short together, repair or replace the Antenna cable as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Antenna base in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .