LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (C510 Manual Transmission (Service Information) - 500) >> Switch, Backup Lamp >> Installation

Switch, Backup Lamp: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152822Courtesy of CHRYSLER GROUP, LLC
  1. Install the switch (2) to transaxle. Tighten the switch to 38 N.m (28 ft. lbs.)
  2. Connect the reverse lamp switch connector (1).
  3. Install belly pan if equipped. Refer to BELLY PAN, INSTALLATION .
  4. Lower vehicle.
  5. Verify reverse lamp operation.
scientia non olet · About LEMON Manuals