LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (C510 Manual Transmission (Service Information) - 500) >> Shaft, Output >> Assembly

Shaft, Output: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install the rear bearing race to the shaft using the Bearing Splitter (special tool #P-334, Splitter, Bearing).
    GC0153703Courtesy of CHRYSLER GROUP, LLC
  2. Install needle bearing (1).
    GC0152632Courtesy of CHRYSLER GROUP, LLC
  3. Install the first and second gear synchronizer hub assembly using (special tool #C-3095-A, Installer, Bearing).
    GC0152610Courtesy of CHRYSLER GROUP, LLC
  4. Install the snap ring.
    GC0152614Courtesy of CHRYSLER GROUP, LLC
  5. Install the needle bearing.
    GC0152633Courtesy of CHRYSLER GROUP, LLC
  6. Install the second/third driven gears, third gear spacer and the fourth driven gear to the main shaft.
    GC0152634Courtesy of CHRYSLER GROUP, LLC
  7. Using Bearing Installer (special tool #L-4507, Installer, Bearing) (1), press the gears into place.
    GC0153704Courtesy of CHRYSLER GROUP, LLC
  8. Using (special tool #L-4507, Installer, Bearing) (1) install the new rear bearing (3) into place, install the new  snap ring to the bearing.
scientia non olet · About LEMON Manuals