LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (C510 Manual Transmission (Service Information) - 500) >> Removal

Section 61 (C510 Manual Transmission (Service Information) - 500): Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove battery tray. Refer to TRAY, BATTERY, REMOVAL .
  2. Remove air cleaner assembly. Refer to AIR CLEANER, REMOVAL .
  3. Remove front fascia. Refer to FASCIA, FRONT, REMOVAL .
  4. Recover the refrigerant from the refrigerant system. Refer to STANDARD PROCEDURE .
  5. Drain engine coolant. Refer to STANDARD PROCEDURE .
    GC0152556Courtesy of CHRYSLER GROUP, LLC
  6. Remove both right and left vertical braces.
  7. Remove both head lamp assemblies. Refer to UNIT, HEADLAMP, REMOVAL .
  8. Remove the cooling system module.
  9. Remove the charged air cooler outlet hose from throttle body.
  10. Remove the ground strap from the transmission.
    GC0152745Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect reverse lamp switch connector (1).
    GC0155856Courtesy of CHRYSLER GROUP, LLC
  12. Remove the concentric slave cylinder hose (2) and secure out of the way.
    GC0152746Courtesy of CHRYSLER GROUP, LLC
  13. Disconnect shift selector cable (1) from the lever.
    GC0157836Courtesy of CHRYSLER GROUP, LLC
  14. Disconnect the cables from the mounting bracket by pulling collar (1) back and lifting cable up.
    GC0152839Courtesy of CHRYSLER GROUP, LLC
  15. Disconnect the shift cable (1) from lever.
    GC0152751Courtesy of CHRYSLER GROUP, LLC
  16. Remove upper bell housing bolts (1).
  17. Raise vehicle on hoist.
  18. Remove the belly pan if equipped. Refer to BELLY PAN, REMOVAL .
    GC0152753Courtesy of CHRYSLER GROUP, LLC
  19. Remove the cross car cradle brace (1).
  20. Drain the transaxle fluid Refer to STANDARD PROCEDURE .
  21. Remove both halfshafts. Refer to REMOVAL .
  22. Remove the starter. Refer to STARTER, REMOVAL .
    GC0152748Courtesy of CHRYSLER GROUP, LLC
  23. Disconnect the oxygen sensor wire from the loom/clip (1).
  24. Disconnect oxygen sensor electrical connector.
  25. Remove exhaust extension pipe.
  26. Carefully support the engine with a screw jack or the equivalent.
  27. Install a suitable transmission jack to the transmission.
    GC0152988Courtesy of CHRYSLER GROUP, LLC
  28. Remove the left side bolts (1) and mount.
    GC0157664Courtesy of CHRYSLER GROUP, LLC
  29. Loosen the rear transmission mount bolt (4) from the frame.
    GC0152755Courtesy of CHRYSLER GROUP, LLC
  30. Remove the rear transmission mount bracket bolt (1) and bracket from transmission.
    GC0152757Courtesy of CHRYSLER GROUP, LLC
  31. Remove the remaining transmission bell housing bolts (3).
  32. Remove the nut (1) holding the transmission to the engine.
  33. Pull the engine forward to gain clearance for the stud passing through the engine block.
  34. Remove transaxle from vehicle.
scientia non olet · About LEMON Manuals