LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 61 (C510 Manual Transmission (Service Information) - 500) >> Input Shaft, Transmission >> Assembly

Input Shaft, Transmission: Assembly

WARNING: This page is about a different variant/trim than selected.
GC0153714Courtesy of CHRYSLER GROUP, LLC
  1. Install the hub and the third gear to the shaft using (special tool #P-334, Splitter, Bearing).
    GC0153715Courtesy of CHRYSLER GROUP, LLC
  2. Install the collar using (special tool #P-334, Splitter, Bearing)

    .

    GC0153710Courtesy of CHRYSLER GROUP, LLC
  3. Install the sleeve and detents to the hub assembly.
    GC0153709Courtesy of CHRYSLER GROUP, LLC
  4. Install the forth driven gear, thrust washer and blocker ring from the shaft.
    GC0153716Courtesy of CHRYSLER GROUP, LLC
  5. Install the rear input shaft rear bearing (3), spacer (2) and collar using (special tool #P-334, Splitter, Bearing) and (special tool #8145, Installer, Bushing) (1).
    GC0153713Courtesy of CHRYSLER GROUP, LLC
  6. Install the front bearing using (special tool #P-334, Splitter, Bearing).
scientia non olet · About LEMON Manuals