Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. | NEW FASTENER* |
|---|---|---|---|---|
| Nut, Hub | 310 | 229 | - | X |
| Nut, Tie Rod End to Knuckle | 40 | 39 | - | |
| Nut, Strut Clevis to Knuckle | 75 | 55 | - | |
| Bolt, Wheel Speed Sensor | 8 | - | 71 | |
| * Bolt, Inner CV joint to Electric Drive Unit (see note) | 30 | 22 | - | |
| *NEW FASTENER: Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications. | ||||
NOTE:
* THE BOLT(S) AND WASHERS MUST BE NEW. If the bolts were threaded into the flange, discard the bolts and washers. Do not reuse the bolts or washers to attach the half shaft to the Electric Drive Unit.