LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Electric Powertrain System - 500 - Electric) >> Electric Vehicle Drive Unit >> Mount, Motor >> Installation >> Right

Mount, Motor: Installation: Right

WARNING: This page is about a different variant/trim than selected.
GC0157609Courtesy of CHRYSLER GROUP, LLC
  1. Install the right motor mount (1), and install the three motor mount bolts (2). Tighten the bolts to 55 N.m (41 ft. lbs.).
    GC0157753Courtesy of CHRYSLER GROUP, LLC
  2. Install and tighten the right motor mount through-bolt (1) to 100 Nm (74 ft. lbs.).
    GC0157840Courtesy of CHRYSLER GROUP, LLC
  3. Install the two Battery Coolant Heater (BCH) nuts (2) and tighten to 20 Nm (15 ft. lbs.).
  4. Install the BCH ground strap bolt (1) and tighten to 12 Nm (9 ft. lbs.).
    GC0157809Courtesy of CHRYSLER GROUP, LLC
  5. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
scientia non olet · About LEMON Manuals