LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Electric Powertrain System - 500 - Electric) >> Electric Vehicle Drive Unit >> Motor, Electric >> Removal

Motor, Electric: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:

When performing any repairs that involve contact with high voltage components or systems, the technician performing repairs on the vehicle must verify that the system remains powered down during high voltage repairs.

  • This must be done by removing the service disconnect.
  • The high voltage power down procedure must also be performed to ensure that the vehicle is properly powered down.
  • The technician must know the whereabouts of the service disconnect throughout the repair.
  • The technician must ensure that no one reconnects the service disconnect while service is being performed.
  • The technician must recheck that the service disconnect has not been reinstalled in cases where the vehicle was unattended.
  1. Remove the electric drive unit (EDU). Refer to UNIT, ELECTRONIC DRIVE, REMOVAL .
    GC0157720Courtesy of CHRYSLER GROUP, LLC
  2. Remove the six electric motor-to-gearbox bolts, and separate the electric motor from the gearbox.
  3. Remove the motor-to-gearbox O-ring seal.
  4. If the electric motor is being replaced, drain and cap the coolant port connections.
scientia non olet · About LEMON Manuals