Brake Operating Unit - Bleed Procedure
WARNING: This page is about a different variant/trim than selected.
multimedia:A supplement to the article is available.
NOTE:
The Brake Operating Unit must be bled using a scan tool. The location and name of the bleeder is listed below as well as it can be found in DESCRIPTION .
| 1. PFS Low Pressure Chamber Bleeder Screw 1 | 3. Boost Chamber Inlet Bleeder Screw 3 |
| 2. PFS High Pressure Chamber Bleeder Screw 2 |
- Follow the scan tool on-screen instructions to properly bleed the Brake Operating Unit. Use the graphics above to identify the proper bleeder screws to open/close based on the scan tool information.