LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 57 (Clutch System - 500) >> Pedal And Pad, Clutch >> Removal

Pedal And Pad, Clutch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the battery negative cable from its post on the battery.
  2. If equipped, remove the knee blocker air bag. Refer to AIR BAG, KNEE BLOCKER, REMOVAL .
    GC0158840Courtesy of CHRYSLER GROUP, LLC
  3. Remove intermediate shaft pinch bolt (2) and separate the intermediate shaft (1) at the base of the column from the steering gear pinion shaft (3). Discard the pinch bolt (2); it is not to be reused. 
  4. Position the intermediate shaft (1) so that the pedal assembly can be accessed.
    GC0153057Courtesy of CHRYSLER GROUP, LLC
  5. Remove the two mounting bolts (1) from the support bracket (2).
  6. Remove the support bracket (2).
  7. Raise and support the vehicle.
    GC0152955Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the supply pipe (1) from the master cylinder and plug both openings.
  9. Remove the support and lower the vehicle.
  10. Remove the battery tray. Refer to TRAY, BATTERY, REMOVAL .
    GC0152954Courtesy of CHRYSLER GROUP, LLC
  11. Remove the supply hose (1) from the brake master cylinder and plug both openings.
    GC0152957Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the clutch start (1) and brake lamp switches (2).
    GC0155758Courtesy of CHRYSLER GROUP, LLC
  13. Disengage clips (1) on booster rod keeper assembly retainer (2). Position retainer (2) up to remove booster rod from pedal assembly.
    GC0152958Courtesy of CHRYSLER GROUP, LLC
  14. Remove the mounting nuts and remove the clutch pedal/brake pedal assembly.
scientia non olet · About LEMON Manuals