LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Vehicle Theft Security (Service Information) 500 - Electric) >> Antenna, Sentry Key >> Removal

Antenna, Sentry Key: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0157668Courtesy of CHRYSLER GROUP, LLC
  1. Perform the 12-Volt Power Down procedure. Refer to 12-VOLT POWER DOWN .
  2. Remove both the upper and lower shrouds from the steering column. Refer to COLUMN, REMOVAL .
  3. Disengage the three retainers (1) that secure the perimeter of the Sentry Key antenna (2) to the ignition lock cylinder housing.
  4. Disconnect the steering column wire harness connector (3) from the antenna connector receptacle.
  5. Remove the Sentry Key antenna from the ignition lock cylinder housing.