LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 55 (Vehicle Theft Security (Service Information) 500 - Electric) >> Antenna, Sentry Key >> Installation

Antenna, Sentry Key: Installation

WARNING: This page is about a different variant/trim than selected.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the Intelligent Battery Sensor (IBS)/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0157668Courtesy of CHRYSLER GROUP, LLC
  1. Position the Sentry Key antenna (2) close enough to the ignition lock cylinder housing to access and connect the steering column wire harness connector (3) to the antenna connector receptacle.
  2. Position the antenna over the end of the ignition lock cylinder and engage the three retainers (1) that secure the antenna to the lock cylinder housing.
  3. Install the upper and lower shrouds onto the steering column. Refer to COLUMN, INSTALLATION .
  4. Perform the 12-Volt Power Up procedure. Refer to 12 VOLT POWER UP .
scientia non olet · About LEMON Manuals