Lamp, Cargo: Removal: Lamp
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- On vehicles equipped with the high voltage system, power down the 12 volt system, Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12 volt battery cable.
- Locate the cargo lamp (3) in the rear edge of the left quarter trim panel (2) near the trunk side trim panel (1).
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the notched lower end of the cargo lamp lens to disengage the lower end of the lamp housing from the mounting hole in the quarter trim panel.
- Pull the upper end of the lamp housing out of the mounting hole far enough to access and disconnect the body wire harness connector from the lamp connector receptacle.
- Remove the cargo lamp from the vehicle.