Switch, Sunroof: Removal
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12 volt battery cable.
- Remove the sunroof switch (2) and bezel (3) from the headliner as a unit and place it on a suitable work surface. Be certain to take the proper precautions to protect the switch and bezel from cosmetic damage. Refer to CONSOLE, OVERHEAD, REMOVAL .
- Remove the two screws (1 and 4) that secure the switch mounting tabs to the back of the bezel.
- Remove the switch from the bezel.