Standard Procedure - Sunroof Initialization: REINITIALIZATION
WARNING: This page is about a different variant/trim than selected.
The following procedure causes a previously calibrated and properly operating electronic motor module to relearn and update motor stall position and obstacle detection.
NOTE:
If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1.
- Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed.
- Release the CLOSE push button of the sunroof switch. Wait 5 seconds, then depress and hold the CLOSE push button of the sunroof switch for about 10 seconds until you hear an audible metallic click from the servo motor.
- Release the CLOSE push button of the sunroof switch, then depress and hold the CLOSE push button again within 5 seconds.
- As the CLOSE push button of the sunroof switch is held, the sunroof sliding glass panel will move to the fully closed position, then to the fully opened position and then fully closed again.
- Initialization is complete. Release the sunroof switch push button.