LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 51 (Heated Seats (Service Information) - 500 - Electric) >> Relay, Heated Seat >> Removal

Relay, Heated Seat: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:

Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

GC0152987Courtesy of CHRYSLER GROUP, LLC
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

  1. On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
  2. Disconnect the negative 12 volt battery cable.
  3. Open the cover (1) on the relay receptacle (3), located underneath the front seat (4) being serviced.
  4. Remove the heated seat relay (2) from the relay receptacle.
scientia non olet · About LEMON Manuals