Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read TPM Module DTCs and record on the repair order.
3. With the scan tool, erase TPM Module DTCs.
4. Drive the vehicle at speeds greater than 20 km/h (13 mph) for 10 minutes.
5. With the scan tool, read TPM Module DTCs.
  Is this DTC Active at this time?
  
  Yes
  - Go To 2
  No
  - Go To 4
TIRE PRESSURE MONITORING (TPM) WINTER MODE
NOTE:
Repair all other TPM Module DTCs before continuing with this test procedure.
1. Turn the ignition off.
2. Cycle the ignition from off to on.
3. Check for the following conditions:
  - The telltale lamp is off.
  - The tire pressure values in the Instrument Cluster are displayed as dashes.
  - The message center is not displaying "SERVICE TPM SYSTEM".
  Are all of the above conditions correct?
  
  Yes
  - The Tire Pressure Monitoring (TPM) Module is now in deactivation mode (Winter Mode). This DTC will remain active until the correct tire and wheel assemblies are installed back on the vehicle. Once one of the correct tire and wheel assemblies are reinstalled, the other three must also be reinstalled prior to turning the ignition on.
  No
  - Go To 3
TIRE PRESSURE MONITORING (TPM) SENSORS
1. Turn the ignition off.
2. Verify the correct TPM Sensors are installed in all of the tire and wheel assemblies.
  Are the correct TPM Sensors installed?
  
  Yes
  - Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .
  No
  - Install all new Tire Pressure Monitoring (TPM) Sensors in accordance with the Service Information. Refer to SENSOR, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .
INTERMITTENT TIRE PRESSURE MONITORING (TPM) SENSOR DTC
1. The conditions necessary to set this DTC are not present at this time.
2. Perform any Service Bulletins that may apply to this condition.
3. With the scan tool, erase TPM Module DTCs.
4. Test drive the vehicle for a minimum of 10 minutes with vehicle speed greater than 20 km/h (13 mph).
5. With the scan tool, read TPM Module DTCs.
  Did the DTC return?
  
  Yes
  - Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .
  No
  - Test complete.
  - Perform the TPM VERIFICATION TEST. Refer to STANDARD PROCEDURE - TPM VERIFICATION .