LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Occupant Restraint Controller (Orc) - DTCS B0118-95 To U0127-00 - 500 - Electric) >> DTC Troubleshooting >> B012D-64-Driver Door Pressure Sensor (Satellite) - Signal Plausibility Failure >> Set Condition

Set Condition

WARNING: This page is about a different variant/trim than selected.

This code will set, if the ORC and the Driver Door Pressure Sensor (Satellite) do not establish and maintain valid data communications. The DTC will become Active after the fault has set for a minimum of 100 milliseconds (ms). The DTC will go to Stored after the ORC to Driver Door (Pressure) Sensor communication fault has been removed or the suspect pressure sensor has been replaced. This fault will clear upon the next ignition cycle. The Multifunction Indicator Lamp (MIL) will set in the instrument cluster.

scientia non olet · About LEMON Manuals