Bulb - Turn Signal
WARNING: This page is about a different variant/trim than selected.
NOTE:
The upper front combination lamp unit combines the low beam headlamp bulb and the turn signal lamp bulb in a single lamp unit. This lamp is used only on vehicles manufactured for sale in Mexico and Latin America and replaces the headlamp unit used on vehicles manufactured for sale in the United States and Canada.
- Disconnect and isolate the battery negative cable.
- Reach behind the upper front combination lamp unit housing (1) to access and remove the upper protective rubber boot from the back of the housing.
- Firmly grasp the bulb socket (2) and rotate it counterclockwise about 30 degrees to unlock it.
- Pull the socket and bulb straight out from the keyed opening in the headlamp reflector.
- Pull the base of the bulb (1) straight out of the socket (2).