LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Lamps/Lighting - Exterior (Service Information) 500 - Electric) >> Switch, Backup Lamp >> Diagnosis And Testing >> Diagnosis And Testing - Backup Lamp Switch

Diagnosis And Testing - Backup Lamp Switch

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the battery negative cable.
  2. Locate and disconnect the wire harness connector from the backup lamp switch connector receptacle.
  3. Check for continuity between the two terminal pins in the backup lamp switch connector receptacle.
    1. With the gear selector lever in the REVERSE position, there should be continuity.
    2. With the gear selector lever in any position other than REVERSE, there should be no continuity.
  4. If the switch fails either of these two continuity tests, replace the ineffective backup lamp switch.
scientia non olet · About LEMON Manuals