Lamp, Side Marker: Removal: Lamp
WARNING: This page is about a different variant/trim than selected.
NOTE:
A side marker lamp is integral to the front fascia forward of each front wheel opening and to the rear fascia behind each rear wheel opening.
- Disconnect and isolate the battery negative cable.
- Remove enough of the fasteners that secure the front of the front wheel house splash shield to the front fascia, or the rear of the rear wheel house splash shield to the rear fascia to gain access to the back of the side marker lamp housing. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL or SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
- Disconnect the wire harness connector (1) from the side marker lamp bulb socket.
- Remove the two stamped nuts (2) that secure the lamp housing to the fascia.
- Remove the side marker lamp from the fascia.