Lamp, Fog: Installation: Bulb
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
CAUTION:
Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.
- Align the front fog lamp bulb (2) with the keyed opening on the back of the lamp housing (1).
- Insert the bulb into the housing until the base is firmly seated.
- Rotate the bulb clockwise about 30 degrees to lock it into place. The bulb connector receptacle should be oriented toward the bottom of the lamp housing.
- Reinstall the fog lamp into the front fascia. Refer to LAMP, FOG, INSTALLATION .
- Reconnect the battery negative cable.
- Confirm proper front fog lamp alignment. Refer to STANDARD PROCEDURE - LAMP ALIGNMENT .