Lamp - Hatchback
WARNING: This page is about a different variant/trim than selected.
- Open the liftgate.
- Disconnect and isolate the battery negative cable.
- Unsnap the plastic covers over the two mounting holes (1) used to secure the upper trim cover to the inner liftgate panel above the glass.
- Remove the two screws that secure the upper trim cover to the inner liftgate panel.
- Pull the upper trim cover away from the liftgate far enough to access the Center High Mounted Stop Lamp (CHMSL) (2) secured to the back of the trim cover.
- Disconnect the wire harness connector (1) from the connector receptacle on the left end of the CHMSL socket plate.
- Remove the two screws that secure the CHMSL to the back of the upper trim cover.
- Remove the CHMSL from the back of the upper trim cover.